N20 help-04 Z06

Reply Subscribe

Thread Tools

Search this Thread

Nov 4, 2007 | 03:28 PM

blk04z

Thread Starter

11 Second Club

Joined: Jun 2006

Posts: 156

Likes: 0

From: New Jersey

N20 help-04 Z06

Need to find throttle position and tach signal off my computer to to finish my fjo controller install. I searched but couldnt find anything. Thanks

Nov 4, 2007 | 03:51 PM

z06 mike

Teching In

Joined: Aug 2007

Posts: 20

Likes: 0

From: Belton,tx

I have installed the tach wire on the number 10 pin should be a white wire.

Nov 4, 2007 | 06:45 PM

99FRC

TECH Enthusiast

iTrader: (5)

Joined: Jun 2005

Posts: 687

Likes: 0

From: Dallas, Texas

I took TPS signal off of the throttle boby (blue wire) and Tach signal from the white wire in the wiring harness under the driver's side dash. There are about four of them (white wires), but I used a volt meter and a needle to find the right one (rev the engine and see which one has variation). It think there's a post with good pics in the nitrous section, wiring sticky on how to find it.

Patience is a must on this part. Good luck!

99 FRC

Reply Subscribe