Drivetrain issue - HELP
Also the car shifts normal, there are no weird noises coming from the shifter area when idling or driving, and there are no weird noises coming from the shifter area when the clutch pedal is pressed in or depressed.
Last edited by c5_ls1_6spd; Aug 5, 2008 at 03:45 PM.
When you say you lay into it at 2.5krpms is the car in nuetral also. If so worst case would be torque tube bushings. Most likely I would think its just the lack of rotational mass to dampen any vibration under te rapid throttle acceleration.
When you say you lay into it at 2.5krpms is the car in nuetral also. If so worst case would be torque tube bushings. Most likely I would think its just the lack of rotational mass to dampen any vibration under te rapid throttle acceleration.
The car never vibrated until I had the aluminum flywheel and spec 3+ installed. when I say lay into, I'm speaking about the car being under load. Going up a hill or on a level surafce, the clutch does not slip at. The vibrations due however go away at high rpm. It seems as though it vibrates from about 2k to 5k and then it's smoothes out again. Between 2k and 5k, the shifter shakes violently and when I grab the shifter it feels like my arm is about to be shook loose. Also if I put the car in neutral while rolling or stopped and depress the clutch and rev it up, the shifter and car vibrates. I'm thinking I have a warped flywheel or clutch, but I'd like you alls opinions too.
When you say you lay into it at 2.5krpms is the car in nuetral also. If so worst case would be torque tube bushings. Most likely I would think its just the lack of rotational mass to dampen any vibration under te rapid throttle acceleration.
werd.
Also the car shifts normal, there are no weird noises coming from the shifter area when idling or driving, and there are no weird noises coming from the shifter area when the clutch pedal is pressed in or depressed.


