Drag Racing Tech
Sponsored by:
Sponsored by:

getting ready to install wolfe 10 point a few ??

Old Jan 29, 2009 | 06:49 PM
  #1  
dschmittie1's Avatar
Thread Starter
10 Second Club
iTrader: (64)
 
Joined: Aug 2005
Posts: 2,344
Likes: 2
From: York, PA
Default getting ready to install wolfe 10 point a few ??

Well my Wolfe 10 showed up this week and I am gonna start gutting my car after this weekend. My question is do I NEED to remove everything from behind the dash or is there some stuff I can leave in during the install. Also how much stuff am I gonna have to loose. I plan on retaining my heat at least. Probably gonna ditch the AC while I am at it but not 100% sure yet. I need to be able to at least retain my defrost since I do drive the car a fair amount. I just know I never used my ac last year plus it will free up some room under the hood.

Any other advice while I am at it would be good.
Reply
Old Jan 29, 2009 | 08:59 PM
  #2  
JUICED96Z's Avatar
TECH Addict
iTrader: (2)
 
Joined: Jul 2002
Posts: 2,970
Likes: 1
From: Indy
Default

WOLFE told me the bar that runs under the dash is not NHRA required, I wanted to run it though on my 96.

The guys installing it said the HVAC box had to come out so they ditched it. I rear a frew threads on here how you can modify it and it will work... it was a long time ago, may be a DIY heater thing.

Be carefull pulling the dash pad, most poeple split them. A lot easier with that and the welding if you pull the glass.
Reply


Thread Tools
Search this Thread

All times are GMT -5. The time now is 11:10 PM.