dynatechs vs single chamber flows
#1
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Mar 2007
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
dynatechs vs single chamber flows
So right now I I'm running a 3'' x pipe and flowtech afterburner mufflers dumped at the axle. I'm wanting to switch to something else and I have come to the conclusion of dynatech splitflows and single chamber flows. Is there any weight difference? How is the drone and resonance between the two? Is there any flow difference? BTW I have already had dynatechs on this car but I was running them straight off the headers so I'm wondering how much the x pipe would change the sound.
The biggest question I have is will I notice much or any performance difference from the flowtechs to either of these other mufflers?
The biggest question I have is will I notice much or any performance difference from the flowtechs to either of these other mufflers?
Last edited by fossilrunner; 02-24-2010 at 09:44 AM.
#2
I don't have a direct comparison but I do run the splitflows. The x pipe will quiet it down a bit and should improve low end torque as well. The spliflows are a straight thru design so no real restricltion at all.
#5
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Mar 2007
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
This is with the x pipe and flowtechs.http://www.youtube.com/watch?v=9p0Nr-6LzhU
This is with the dynatechs off the headers http://www.youtube.com/watch?v=BFZf362pEto
This is with the dynatechs off the headers http://www.youtube.com/watch?v=BFZf362pEto