inconsistent reaction times with yank

Reply Subscribe

Thread Tools

Search this Thread

Aug 27, 2013 | 05:05 PM

cj92345

Thread Starter

Teching In

iTrader: (2)

Joined: Sep 2012

Posts: 36

Likes: 0

inconsistent reaction times with yank

pulled out a hughes 2500 put in a yank 4000, r/t's are all over the place now, e/t is consistant 8.29 8.30 8.28...reaction times suck, tried going deep, mostly shallow stage i'am either .002 or .112

bring rpm up to about 1400....maybe bring it higher?...can't get a handle on it..any advise? would cut more consistant light with hughes converter....lower stall may be a factor
tired or donating to the pot and going home

Aug 27, 2013 | 07:10 PM

1BAD98LS1

11 Second Club

iTrader: (33)

Joined: Aug 2004

Posts: 819

Likes: 1

From: Gloucester, VA

Bring up your launch rpm to 24-2500ish. If the brakes won't hold than try 2k range.

Sep 3, 2013 | 05:00 AM

Slowhawk

LS1Tech Sponsor

iTrader: (12)

Joined: Nov 2001

Posts: 14,865

Likes: 6

From: Bridgewater,Ma

1400 is too low. I use to run mine 2500-3000 and hit the lights consistent.

Sep 3, 2013 | 05:08 AM

ironmanLS1

TECH Regular

iTrader: (9)

Joined: Jul 2012

Posts: 422

Likes: 12

From: Export, PA

Is your 60' consistent? If it is moving around .02 or so part of it could be the tires. Usually that will should up at the big end but it doesn't look too bad there. Usually the driver in my case.