msd 2 step
#1
msd 2 step
What a good starting point to set 2 step at? th400 with Trans brake 408 super Victor intake with induction solutions plate pill for 300hp jet 3400 race weight 28.10.5 slick
#5
1st gear, turn trans brake on (2step off), put it to the floor, whatever rpm it goes to or "tops out" at, subtract 1,000 rpm and pill it or dial it there. Don't do it for more than a couple seconds and don't do it in Nuetral. Adds a ton of heat quick especially on a small converter. If it don't hook keep dropping launch rpm till it does. Or play with suspension till it hooks. I like the later. Its more challenging.
#6
1st gear, turn trans brake on (2step off), put it to the floor, whatever rpm it goes to or "tops out" at, subtract 1,000 rpm and pill it or dial it there. Don't do it for more than a couple seconds and don't do it in Nuetral. Adds a ton of heat quick especially on a small converter. If it don't hook keep dropping launch rpm till it does. Or play with suspension till it hooks. I like the later. Its more challenging.
Ok will do thanks
#7
1st gear, turn trans brake on (2step off), put it to the floor, whatever rpm it goes to or "tops out" at, subtract 1,000 rpm and pill it or dial it there. Don't do it for more than a couple seconds and don't do it in Nuetral. Adds a ton of heat quick especially on a small converter. If it don't hook keep dropping launch rpm till it does. Or play with suspension till it hooks. I like the later. Its more challenging.