Jegster roll cage
Thread Starter
Teching In
Joined: Jun 2002
Posts: 31
Likes: 0
From: Tomball
Jegster roll cage Has any one had any experience with this roll cage? I just noticed it in my Jeg's catalog and was wondering if any one has used one of them. I am not sure if the are bolt in or weld in. There are many different points available(4,6,8,10,12) I'll probaly be goin with the 6 or the 8 which are <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" /> $149.99 and $199.99 <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" /> .
Thanks <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Thanks <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
TECH Junkie
Joined: Nov 2001
Posts: 3,987
Likes: 0
From: Melbourne, FL
Re: Jegster roll cage I don't have any personal experience with it, but it is a weld-in type bar which will require some know-how to install. It's pretty much the same deal as the SW rollbar, if you've ever seen/heard of them. You'll have to notch the bar ends and trim the door bars/rear bars depending on where you place them, and of course TIG weld it together (I'm not sure if it's legal to MIG weld a rollbar for a 10.0-up car).
In any case, it's not a plug and play type deal...
In any case, it's not a plug and play type deal...
Re: Jegster roll cage I believe you can MIG a mild steel cage, but TIG is required on a Chromoly cage.
You can see some of the stuff I did to put in my S&W
near the bottom, http://harlan-engineering.com/hawk/mods/mods.html
I've done a few more since then, invest in a tubing notcher if you're gonna do it. It cuts the install time more than in half
good luck <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />
You can see some of the stuff I did to put in my S&W
near the bottom, http://harlan-engineering.com/hawk/mods/mods.html
I've done a few more since then, invest in a tubing notcher if you're gonna do it. It cuts the install time more than in half
good luck <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />
