How to measure for new DS???
Thread Starter
12 Second Club
Joined: Sep 2002
Posts: 547
Likes: 0
From: Minnesota
How to measure for new DS??? Hey guys I just installed a 9" into my car now I need to measure up for the new DS. How do I go about doing this? If it matters the car is a M6 and the new 9" has the 1350 Yoke.
Dan
Dan
Hello,
Most companies require a measurement from the center of the rear u-joint to the seal surface of the trans tail shaft and the amount of output shaft outside of the seal surface. These measurements should be taken with the suspension loaded.
Most companies require a measurement from the center of the rear u-joint to the seal surface of the trans tail shaft and the amount of output shaft outside of the seal surface. These measurements should be taken with the suspension loaded.
