Something of a setup question here. . .SS Hoods
Thread Starter
11 Second Club
iTrader: (103)
Joined: Aug 2005
Posts: 2,633
Likes: 1
From: South of West Point Iowa
Something of a setup question here. . .SS Hoods Alright. I got a hood CHEAP and decided to do a pin-on type. Now, the underside was pretty bad, and the top wasn't much better...
I'm starting on the underside BEFORE I work on the top. That way, I've got the bottom structure done before I mess up the top. I'll be using a few strategically placed aluminum bars and fiberglass, but now I'm wondering if I should continue on w/FULL pin-on, OR use the hinges and front pin-down, OR scrap the whole under support and go dzus .... like Madmans setup as seen here. . .
My current underside...
Top started, but postponed until bottom done.
I'm starting on the underside BEFORE I work on the top. That way, I've got the bottom structure done before I mess up the top. I'll be using a few strategically placed aluminum bars and fiberglass, but now I'm wondering if I should continue on w/FULL pin-on, OR use the hinges and front pin-down, OR scrap the whole under support and go dzus .... like Madmans setup as seen here. . .
My current underside...
Top started, but postponed until bottom done.
Thread Starter
11 Second Club
iTrader: (103)
Joined: Aug 2005
Posts: 2,633
Likes: 1
From: South of West Point Iowa
Never heard back from the original owner, but I decided I IDOLIZE Madman and his work SOOOO much, I'm gonna Dzus it.
Since is IS an original SLP SS hood:
Since is IS an original SLP SS hood:
