Dyno'd the new setup
Dyno'd the new setup Well I installed some LS6 heads I got off here that I sent to TSP for CNC work. I got a 230/236 cam off a member on here also and a LS6 intake. Previous dyno numbers were 323hp/333lb-ft. I went out yesterday with the new setup and made a few more pulls to see where I stand. Car made 410hp/385lb-ft. I was hoping for a little more, so i'll have to finish the free mods and bolt ons. Next up is an under drive pulley, ported TB, and a better y-pipe/cutout setup.
Do these numbers seem about right?
William
p.s. Forgot to mention the heads were milled to 61cc and I'm running a cometic .040 gasket (compression should be around 11.5:1 static).
Do these numbers seem about right?
William
p.s. Forgot to mention the heads were milled to 61cc and I'm running a cometic .040 gasket (compression should be around 11.5:1 static).
