Iron 404 Dyno Results
08-17-2007, 03:59 PM
#1
Iron 404 Dyno Results Here is my set-up:
New LQ9 Block Bored .010 over
Callies Magnum 4.0 in. Stroker Crank
Callies Compstar Rods
Diamond -10cc Pistons
Stage 2 5.3 60cc Heads 2.02/1.57 Valves
Comp XE-R 245/250 .611 .614 on 112
Ported FAST 90 and NW 90.
UD Pulley
K&N FIPK Intake with Stock MAF
Jet Hot 1 3/4 Headers, Hooker ORY, Magnaflow Exhaust.
Delfi-Lucas 42# injectors, Racetronix PNP Kit
Tuned By Jeremy Formato
The car made 502 rwhp and 463 rwtq.
I didn't even open the cut-out for the dyno runs because I forgot about it and the car was already strapped down. So I think it still has some in it.
I will try to post up the print out tonight. I'm real happy with the results but please tell me what you think.
New LQ9 Block Bored .010 over
Callies Magnum 4.0 in. Stroker Crank
Callies Compstar Rods
Diamond -10cc Pistons
Stage 2 5.3 60cc Heads 2.02/1.57 Valves
Comp XE-R 245/250 .611 .614 on 112
Ported FAST 90 and NW 90.
UD Pulley
K&N FIPK Intake with Stock MAF
Jet Hot 1 3/4 Headers, Hooker ORY, Magnaflow Exhaust.
Delfi-Lucas 42# injectors, Racetronix PNP Kit
Tuned By Jeremy Formato
The car made 502 rwhp and 463 rwtq.
I didn't even open the cut-out for the dyno runs because I forgot about it and the car was already strapped down. So I think it still has some in it.
I will try to post up the print out tonight. I'm real happy with the results but please tell me what you think.
Last edited by mochiles; 08-18-2007 at 02:01 AM.
Trending Topics
08-19-2007, 01:47 AM
#12
12 Second Club
iTrader: (33)
Join Date: Jan 2005
Location: winter springs, fl
Posts: 2,584
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by mochiles
Ha ha! You want to see me break my rear end don't you.
08-19-2007, 09:56 AM
#13
Originally Posted by ls2 bait
still rockin a 10 bolt? what gear?
08-19-2007, 03:45 PM
#14
12 Second Club
iTrader: (33)
Join Date: Jan 2005
Location: winter springs, fl
Posts: 2,584
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by mochiles
Yes unfortuately I am, with 3.42s. A 9" was my next project but when my motor went, plans had to change. All I can do is keep my fingers crossed and hope it holds out.
08-20-2007, 12:22 AM
#17
Originally Posted by MPHmotorsports
Very nice results. Congs.
I was expecting about 480-485 tops so it defentially made more power then I thought it would.
Have fun
I was expecting about 480-485 tops so it defentially made more power then I thought it would.
Have fun
See ya around old roomie 
