Magnaflow Catback for sale
Thread Starter
On The Tree
iTrader: (6)
Joined: May 2008
Posts: 159
Likes: 0
From: Gap, PA/Kutztown PA
Magnaflow Catback for sale I just got a custom catback because the magnaflow was just to quite at idle for me after my Lt's and High flow cats.
I will post pics tomorrow of it.
The catback has no tips i had them taken off because i did really like them and i had them welded onto my new Exhaust setup. It is the 3"inlet 2.5 outlet, and it was on the car when i bought it and it was welded together, I had to cut it in the i pipe BEFORE the axle where it is straight before it bends upwards, but i made sure that they cut it before it bent up so it could easily be welded or just Clamped together. I would like a local pick up and i could meet someone.
I live in Lancaster County when i go back from school some weekends, Or somebody around Reading or Allentown area, I go to school at kutztown and i have it in the back of my car now. I also will be going to Connecticut next weekend so Anybody near I-95 from the outskirts of philly Up 95 to NewHaven, then i get onto I-91 all the way up until the last exit in CT. I can even go up past Springfield MA. So anybody on my way or somewhere near my school or house. I do not mind driving up to an hour or so, and maybe for just a couple $ more up to 2 hours.
It is the I pipe that is cut before the axle but is a straight cut,Over the axle, Then welded into the Muffler and then the outlets are welded into the muffler to with NO tips. So all you need is a Clamp and some tips and it is all set to go
Looking for 150 OBO and I will post pictures Tomorrow when i can get to my car , it is covered in snow in my schools parking lot right now
I will post pics tomorrow of it.
The catback has no tips i had them taken off because i did really like them and i had them welded onto my new Exhaust setup. It is the 3"inlet 2.5 outlet, and it was on the car when i bought it and it was welded together, I had to cut it in the i pipe BEFORE the axle where it is straight before it bends upwards, but i made sure that they cut it before it bent up so it could easily be welded or just Clamped together. I would like a local pick up and i could meet someone.
I live in Lancaster County when i go back from school some weekends, Or somebody around Reading or Allentown area, I go to school at kutztown and i have it in the back of my car now. I also will be going to Connecticut next weekend so Anybody near I-95 from the outskirts of philly Up 95 to NewHaven, then i get onto I-91 all the way up until the last exit in CT. I can even go up past Springfield MA. So anybody on my way or somewhere near my school or house. I do not mind driving up to an hour or so, and maybe for just a couple $ more up to 2 hours.
It is the I pipe that is cut before the axle but is a straight cut,Over the axle, Then welded into the Muffler and then the outlets are welded into the muffler to with NO tips. So all you need is a Clamp and some tips and it is all set to go
Looking for 150 OBO and I will post pictures Tomorrow when i can get to my car , it is covered in snow in my schools parking lot right now
