Looks like it is gonna be real slow, huh. 
New setup almost complete....pic within
Thread Starter
Joined: Nov 2001
Posts: 8,484
Likes: 0
From: Cecil County Raceway!!!
Originally Posted by midnightsun13
and after all that....youve got duct tape holding the lid down.....classic
Thread Starter
Joined: Nov 2001
Posts: 8,484
Likes: 0
From: Cecil County Raceway!!!
Originally Posted by WS6TransAm01
Fireball,
Whats the story on heat soak with the single plane intake?
Whats the story on heat soak with the single plane intake?
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I bet that you could hav a bunch of mat'l removed off the top of that intake, and the intake elbow flange where they bolt together, that would probably make the clearance issues alot less. not gonna completely solve the problem, but alot of it. I bet that between the top of the intake, and the elbow, there'a about 3/4 of an inch that could be milled off.
I'm very intrested to see how this setup works out for you.. it, along with a bigger cam were the next 2 things that I was considering doing, and your results with it ona 346 motor could swing my decision.
I'm very intrested to see how this setup works out for you.. it, along with a bigger cam were the next 2 things that I was considering doing, and your results with it ona 346 motor could swing my decision.
I'd shave enough so that it would fit under the cowl and not hit the hood, that's all.
The GM intake, shaved a little and cut the elbow some, and you'd probably be able to clear everything. Hmmmmmm
The GM intake, shaved a little and cut the elbow some, and you'd probably be able to clear everything. Hmmmmmm
Originally Posted by Fireball
being that is raised quite a bit off the valley, I don't see it being a big issue.
That is true... can't wait to see how it works out!
Good Luck!