Rear end Swap, is done!
Thread Starter
Joined: May 2005
Posts: 9,830
Likes: 2
From: Wallingford CT
Rear end Swap, is done! While getting ready to purchase my LS1. I am finally finishing up taking all the parts out of the old car to swap into the new one.
This being.
Moser 12 bolt- 3.42 gears, Trutrac Diff, Upgraded axles, Diff cover girdle. We used an epoxy primer for the paint and it still looks mint. Well it only had 2k miles on it .
BMR Suspension- Adjustable TQ Arm, Rear LCA's, Pan Hard rod. The bolts for the TQ arm are still mint. thats what Loctite RED gets yea!!
Denny's n2o ready 3" steel DS- Its a little over kill but its cut for the Moser, and I'll have the proper slip travel.
Corsa Cat Back Exhaust- The fully polished tips, and All that needs to be done is match it up the current exhaust. Its all welded so I dropped it out when I did the rear.
Id like to do a stock motor (no mods to the engine or exhaust manifold) best time with just launching it off of the limiter. I'll have to get a good clutch but oh well, thats the game!
I got a stock 10 bolt from JL-ws6 in there so I can roll her out and sell the 94 as a hardtop roller.
Wish me luck!
This being.
Moser 12 bolt- 3.42 gears, Trutrac Diff, Upgraded axles, Diff cover girdle. We used an epoxy primer for the paint and it still looks mint. Well it only had 2k miles on it .
BMR Suspension- Adjustable TQ Arm, Rear LCA's, Pan Hard rod. The bolts for the TQ arm are still mint. thats what Loctite RED gets yea!!
Denny's n2o ready 3" steel DS- Its a little over kill but its cut for the Moser, and I'll have the proper slip travel.
Corsa Cat Back Exhaust- The fully polished tips, and All that needs to be done is match it up the current exhaust. Its all welded so I dropped it out when I did the rear.
Id like to do a stock motor (no mods to the engine or exhaust manifold) best time with just launching it off of the limiter. I'll have to get a good clutch but oh well, thats the game!
I got a stock 10 bolt from JL-ws6 in there so I can roll her out and sell the 94 as a hardtop roller.
Wish me luck!
Thread Starter
Joined: May 2005
Posts: 9,830
Likes: 2
From: Wallingford CT
im not looking for much 500$. The interior is decent, nothing to scream about. It comes with BMR SFC already welded in. PCM for a auto. Its Black with grey cloth.
Perfect drag car.
Located in CT.
PM if interested.
Perfect drag car.
Located in CT.
PM if interested.
