ready for the track again
Thread Starter
10 Second Club
iTrader: (10)
Joined: Jun 2005
Posts: 570
Likes: 0
From: cape cod mass
ready for the track again hears some pics of the roll bar we just finished up..now i can go for 10's and not get bitched at for going 11.50, but i did tell them low 12's my first time up 
I'm surprised that anyone would even fab a custom setup in mild steel anymore, my guy doesn't use it for anything anymore.
Looks good though, and will certainly take care of your safety needs. Now just make sure you have all the SFI **** on the car too, (trans shield, flexplate, pulley) and of course the 5 pt harness.
Looks good though, and will certainly take care of your safety needs. Now just make sure you have all the SFI **** on the car too, (trans shield, flexplate, pulley) and of course the 5 pt harness.
I'm surprised that anyone would even fab a custom setup in mild steel anymore, my guy doesn't use it for anything anymore.
Looks good though, and will certainly take care of your safety needs. Now just make sure you have all the SFI **** on the car too, (trans shield, flexplate, pulley) and of course the 5 pt harness.
Looks good though, and will certainly take care of your safety needs. Now just make sure you have all the SFI **** on the car too, (trans shield, flexplate, pulley) and of course the 5 pt harness.
Just because "your guy" doesn't use it- doesn't make it inferior.
Looks good Jason, gl next trip to the track!
