Parts needed asap...
05-24-2008, 05:16 PM
#1
TECH Regular
Thread Starter
iTrader: (4)
Join Date: Mar 2006
Posts: 479
Likes: 0
Received 0 Likes
on
0 Posts
Parts needed asap... Getting ready to button up my rebuild and i just need a few more things. Willing to come pick up. Preferably near the Deltona/Sanford/Orlando area.
-LT1 spark plug wire set (prefer new)
-O2 sensors
-O2 sensor wiring extensions (both sides)
-6speed center console (upper shift panel and shift boot)
-Stock MAF sensor housing (with or without screen)
Soon I will also be in the market for a few other things.
-Racetronix 255lph fuel pump and hot wire kit.
-Window switch (all brands welcome)
-3.73 10bolt gears w/ install kit and rear girdle.
If anybody has these or knows where i can get them, please let me know as soon as you can. Thanks.
-LT1 spark plug wire set (prefer new)
-O2 sensors
-O2 sensor wiring extensions (both sides)
-6speed center console (upper shift panel and shift boot)
-Stock MAF sensor housing (with or without screen)
Soon I will also be in the market for a few other things.
-Racetronix 255lph fuel pump and hot wire kit.
-Window switch (all brands welcome)
-3.73 10bolt gears w/ install kit and rear girdle.
If anybody has these or knows where i can get them, please let me know as soon as you can. Thanks.
05-31-2008, 12:37 PM
#6
TECH Regular
Thread Starter
iTrader: (4)
Join Date: Mar 2006
Posts: 479
Likes: 0
Received 0 Likes
on
0 Posts
I am also looking for an lt1 block with low miles and standard bore. The cylinder walls need to be as close to standard bore as possible. If you have a good block that you were thinking about boring.... DON'T. I already have a block that has been cleaned, with new freeze plugs and cam bearings that i can trade you (it just needs to be bored out).
Long story short, i have a balanced rotating assembly with standard bore pistons and the blocks i have are not with in specs.
Also would be willing to sell either one of the blocks if anyone needs one. May even end up selling the rotating assembly if i can't find a good block. (Stock machined crank, stock rods, KB forged pistons 11:1. Would include piston rings and all associated bearings.)
PM me if you can help me out.
Long story short, i have a balanced rotating assembly with standard bore pistons and the blocks i have are not with in specs.
Also would be willing to sell either one of the blocks if anyone needs one. May even end up selling the rotating assembly if i can't find a good block. (Stock machined crank, stock rods, KB forged pistons 11:1. Would include piston rings and all associated bearings.)
PM me if you can help me out.
