Who could help me out here.......
Thread Starter
TECH Resident
Joined: Mar 2002
Posts: 782
Likes: 0
From: North Las Vegas, NV
Who could help me out here....... I'm using dyno2000 to compare what the program says vs. what I get on the dyno. This is what I need to know
Forced Induction:
I have a P1SC with MMS pulley system.
It asks for the following....
Induction Flow xxx.xcfm @ (1.5 OR 3.0) Hg
Blower(I have to put custom because ATI isn't an option)
Intercooler:
Flow:
Pressure Ratio:
Speed: I'll have to find the calculation again, off the top though it was around 47K or 48K rpms on the blower
Eff: (anyone know what it is on a P1SC1?
The rest of the info it asks for I have I was just wondering if anyone could help me out. I tried looking up on ATI's website but didn't see it. Did I look in the wrong area or do they not post it? Any info would be great. Thanks in advance!
Matt
Forced Induction:
I have a P1SC with MMS pulley system.
It asks for the following....
Induction Flow xxx.xcfm @ (1.5 OR 3.0) Hg
Blower(I have to put custom because ATI isn't an option)
Intercooler:
Flow:
Pressure Ratio:
Speed: I'll have to find the calculation again, off the top though it was around 47K or 48K rpms on the blower
Eff: (anyone know what it is on a P1SC1?
The rest of the info it asks for I have I was just wondering if anyone could help me out. I tried looking up on ATI's website but didn't see it. Did I look in the wrong area or do they not post it? Any info would be great. Thanks in advance!
Matt
11 Second Club
Joined: Jul 2002
Posts: 1,426
Likes: 0
From: Beaver Falls, PA
i went through all that prior to building my motor and just used low generic numbers for all that. you may want to look at the figures for the small vortech blowers they have and try them. don't bother asking ATI, they had no interest in helping me. also, play around with some of the numbers and you may be surprised what result they have. regardless, the program is really just a shot in the dark but actually gave me pretty close results.
Thread Starter
TECH Resident
Joined: Mar 2002
Posts: 782
Likes: 0
From: North Las Vegas, NV
Originally Posted by Texas Terminator
i went through all that prior to building my motor and just used low generic numbers for all that. you may want to look at the figures for the small vortech blowers they have and try them. don't bother asking ATI, they had no interest in helping me. also, play around with some of the numbers and you may be surprised what result they have. regardless, the program is really just a shot in the dark but actually gave me pretty close results.
I was really surprised what it gave me. If it is close and that's the case OMG
