XtremeDime

iTrader: (16)

I wish there was some kind of instructions on how to install these but Im at a loss. Ive got 4 on there so far and I just dont know if they are correct. I know it is ok to have a little gap between the seat and the seal but that seems a bit subjective to me. Also, what socket size should I be using? Im using an 8mm right now, I thought that would keep the seal from tearing out but it looks like it might be bending the spring? Im not sure if its ok for the spring to be a little out of round or not...

Help!

SincalT/A

iTrader: (16)

Dont worry if you dont get them all the way down the retainer will seat it for ya!







Jfwy! Get the kent moore tool or borrow one.

Boo"SS"t

iTrader: (2)

Applying a thin coat of oil in the seal would help from tearing them.

XtremeDime

iTrader: (16)

Switched to using a 13mm socket and things went alot smoother. I replaced some of the bent springs with ones off the stock seals.

Now my Lunati golds are on and looking pretty.

As always, thanks tech.

chevybowtie

iTrader: (16)

The valve spring locators are seperate from the seals with the Lunati kit. The stock ones are one piece which would seat itself. Also the Kent Moore tools is made for the stock one piece. Trust me...I tried to use it on the Lunati valve seals.

SincalT/A

iTrader: (16)

Oh,gotcha thanks.For some reason I had it in my head the Kent Moore tool did the two piece seals.