Preparing for the swap... New parts are in...
Thread Starter
7 Second Club
Joined: May 2007
Posts: 863
Likes: 0
From: Columbus, Ohio
Preparing for the swap... New parts are in... Well, I got the first of the new parts in Yesterday...
my new 105mm Trottle body from Accufab.
The Billet Elbow should be in by the end of next week, new oil pan should arrive Monday, and sometime next week I should be driving down to Souther Indianna to pick up the Long Block.
I think we will run the June 3 Milan race on the Iron Block, then pull it all out for the new engine.
The new setup will be an ERL Superdeck with All Pro Heads, All pro Cast intake, Todd Berry Billet Elbow, Accufab 105mm Trottle body, Solid roller cam, and Jessel rockers.
Old setup was done at about 7400rpms, the new setup will be good to around 8200rpms.
Our hopes are that with the cast intake and solid roller setup we will be able to finally turn up the boost and spin the motor a bit harder down the back of the track.
We will be pushing for 200MPH this year in the 1/4 on the IRS!
my new 105mm Trottle body from Accufab.
The Billet Elbow should be in by the end of next week, new oil pan should arrive Monday, and sometime next week I should be driving down to Souther Indianna to pick up the Long Block.
I think we will run the June 3 Milan race on the Iron Block, then pull it all out for the new engine.
The new setup will be an ERL Superdeck with All Pro Heads, All pro Cast intake, Todd Berry Billet Elbow, Accufab 105mm Trottle body, Solid roller cam, and Jessel rockers.
Old setup was done at about 7400rpms, the new setup will be good to around 8200rpms.
Our hopes are that with the cast intake and solid roller setup we will be able to finally turn up the boost and spin the motor a bit harder down the back of the track.
We will be pushing for 200MPH this year in the 1/4 on the IRS!
Last edited by atomicfusion; May 19, 2011 at 08:02 PM.
