MAP sensor question
Thread Starter
Launching!
iTrader: (1)
Joined: Apr 2011
Posts: 231
Likes: 0
From: Adamsville Tennessee
MAP sensor question Ok, I'll be home off the boat in a few days and my tranny will be out of the shop by then. Everything on my motor is ready except for the purchase of a MAP sensor and wideband. My question is: Is it worth the extra cost to buy a OMNI 3 bar as opposed to a old school gm 3 bar? I'll be running the 411 ECM and HP Tuners to tune.
The OMNI that I viewed looked as though it would plug right into the rear of my Ligenfelter intake, whereas the old school will have to be mounted elsewhere and the hole pluged.
Cosmetics isn't my concern right now as I am using a spliced up truck harness, but later I would like to get a painless or a product of that caliber.
The OMNI that I viewed looked as though it would plug right into the rear of my Ligenfelter intake, whereas the old school will have to be mounted elsewhere and the hole pluged.
Cosmetics isn't my concern right now as I am using a spliced up truck harness, but later I would like to get a painless or a product of that caliber.
