best location for meth nozzle and IAT sensor?
Thread Starter
11 Second Club
iTrader: (21)
Joined: Nov 2003
Posts: 1,497
Likes: 0
From: my own world
best location for meth nozzle and IAT sensor? I have an LT1, D1-SC with twin intercooloers piping runs up driver side radiator into a y-connector = 4". I will have my MAF there and a 4" 90 degree bend 5 ply silicone elbow into my throttle body.
I have a progressive meth kit and Lingenfelter MAF.
I can adapt my factory IAT anywhere in there, and same with the meth nozzle.
Should I spray before the MAF and let it's IAT sensor feed my reading?
Should I spray after the MAF and put the IAT closer to the throttle body, say, in the intake elbow?
What say ye that run meth and watch your intake air temps?
I have a progressive meth kit and Lingenfelter MAF.
I can adapt my factory IAT anywhere in there, and same with the meth nozzle.
Should I spray before the MAF and let it's IAT sensor feed my reading?
Should I spray after the MAF and put the IAT closer to the throttle body, say, in the intake elbow?
What say ye that run meth and watch your intake air temps?
i have heard and read its the best to have the meth before the iat , then its a safeguard in-case the meth fails the iats will be high and timing will be pulled .
