3 Bar MSD
3 Bar MSD Looking to wire in a MSD 2313 MAP sensor.
Gonna buy this http://www.eficonnection.com/eficonn...spx?ItemId=410
and then just pop the stock connector off and pin up this new one. Will the wiring stay the same?
Gonna buy this http://www.eficonnection.com/eficonn...spx?ItemId=410
and then just pop the stock connector off and pin up this new one. Will the wiring stay the same?
i always get a 3bar with a piggy from efi source, for whatever i am going to convert.
its 40 shipped or so with the pigtail
if you cut the stock one off, and go one wire at a time connector tooth up, it will be correct.
its 40 shipped or so with the pigtail
if you cut the stock one off, and go one wire at a time connector tooth up, it will be correct.
