Vic jr intake
Thread Starter
Teching In
Joined: May 2012
Posts: 8
Likes: 0
From: Waynesboro , MS
Vic jr intake I am wanting to use an efi Vic jr on a 6.0 build I'm doing and was wanting to know where to place an IAT sensor. I am planning on running a meth/water injection so I was also needing to know about placement of nozzles where I would get most accurate readings from IAT.
Anywhere after the meth nozzles and as close to the head is best, but anywhere in the intake (after the nozzles) will be fine.
You want it after the meth so the IAT is picking up the actual temp after the meth is in the air charge.
You want it after the meth so the IAT is picking up the actual temp after the meth is in the air charge.
