Chargecooler for Holley Hi-ram
Thread Starter
Teching In
Joined: Jun 2012
Posts: 49
Likes: 0
From: Lithuania, Klaipeda
Chargecooler for Holley Hi-ram Just want to share this to see your opinions.
That is four VORTECH charge cooler cores to make a sandwich for Holley Hi-ram intake manifold. Good enough for 3200CFM flow or 2400hp
That is four VORTECH charge cooler cores to make a sandwich for Holley Hi-ram intake manifold. Good enough for 3200CFM flow or 2400hp
Nicely done 
the thing looks huge. 3200 cfm thats what i need but not sure if I can fit that thing under the hood haha.
Where did you get the vortech coolers, I'd like to check them out?
the thing looks huge. 3200 cfm thats what i need but not sure if I can fit that thing under the hood haha.Where did you get the vortech coolers, I'd like to check them out?
Last edited by v502; Feb 9, 2014 at 06:28 PM.
We did something similar with this core by Whipple
http://www.whipplesuperchargers.com/...sp?ProdID=1226
http://www.whipplesuperchargers.com/...sp?ProdID=1226
Thread Starter
Teching In
Joined: Jun 2012
Posts: 49
Likes: 0
From: Lithuania, Klaipeda
The hood clearance is not an issue, at least for me. Since this thing is going into drag only funny car tube chassis.
