DarkblueTA

What belts do y'all run before you had the SDCE Kit? I was just wondering because I have a 3.85 blower pulley and the MMS crank pulley and I'm seeing 6-7# in San Antonio. I know the belt is slipping because there is belt dust and watching the boost gauge creep up after 4500rpms is a problem.

I see 1# about 3K, 4-5# at 4500 and usually 6-7# at 6K.

Thanks in advance.

1dirtyZ

iTrader: (1)

i don't have the sdce kit yet, but i had the best luck with dayco polycog belts.
they lasted longer than any of the other belts i tried.

DarkblueTA

ok, that's what I'm using now. It seems to be holding up pretty good. No complaints as of yet. I was just wondering what everyone used before they went to the spring tensioner kit. As soon as my next job comes around, I'll pick up the SDCE tensioner kit(I'm a contract worker and its slow right now).