When to kick in the methanol
When to kick in the methanol I put a LSA supercharger on my stock LS3 with a cam. I was going to try to run both the second fuel pump and the methanol/water injection off the same Hobbs switch so when the pressure gets to X amount, it kicks them both on. Roughly what PSI would be good to start the injection?
Pretty basic question I know, but if I can't go this route, I can wire the second fuel pump off another Hobbs switch. I plan on running about 11 psi, maybe more if everything works well.
Pretty basic question I know, but if I can't go this route, I can wire the second fuel pump off another Hobbs switch. I plan on running about 11 psi, maybe more if everything works well.
4lbs is a good start point for the meth ( progressive from there). I can’t answer for the fuel system.
For my $0.02 .... I wouldnt want to depend on both (very important) components of the fuel system being triggered by one Hobbs switch.
For my $0.02 .... I wouldnt want to depend on both (very important) components of the fuel system being triggered by one Hobbs switch.
I am probably going to shoot for 7 psi and see what happens. As for running them both off the same Hobbs switch, they are running to relays, so the Snow system is set to turn on at 7psi, and the second pump will also, but if the Hobbs switch goes bad, the second fuel pump defaults to the "on" position.
Thanks for all the replies!
Thanks for all the replies!
On The Tree
Joined: Apr 2017
Posts: 115
Likes: 6
