650-800hp parts list HELP
Thread Starter
Staging Lane
Joined: Aug 2019
Posts: 61
Likes: 6
From: Lumberton, NJ
650-800hp parts list HELP this may be a little long so bare with me. these are the parts i have.. i have an 04 or 05 5.3 truck engine that has the sensors in the rear, dished pistons and gen 4 rods. billet vs80 turbo, th400 with TCI 3400 stall converter, B&M shifter and cable, FIC1000's and in tank twin 450's with 8 feed and a 6 return, tbss intake manifold with holley rails that im about to order for $120 i think, .660 springs on 706 heads and a stage 2 btr turbo cam that came with timing cover gaskets the crank bushing and water pump gaskets.
so far what i know i need to get and plan to is the terminator x, headgaskets but not sure which ones.. some say ls9 but some say just get replacement 5.3 gaskets like mhale etc. i need a cable driven throttle body that will fit the tbss intake. i was looking at the holley sniper tb on summit its like $180 do you guys have info on them? other than that what else am i missing to get this swap completed? i only have access to 93 pump gas but when i go to the track is when ill buy some e85. also think ill get the denmah kit for intercooler the piping wg and bov. i need info or links to whatevr else you guys think i should get from dipsticks to bolts etc lol. should i just grab new TSP head bolts for $60-80 on their site? what flexplate do i need to look for? the engine has the flywheel still on it. i want to get this swapped and running for as little as possible because ill build a 5.3 block overtime while i drive this set up. but i woukdnt mind this set up lasting for a little while lol im sure the gen 4 rods will survive the power levels im looking for. how about a decent boost controller that isnt top notch for 7 second cars. if im leaving anything out lmk and i will adress it its hard to remember every single piece to an engine off the top of my head lol
so far what i know i need to get and plan to is the terminator x, headgaskets but not sure which ones.. some say ls9 but some say just get replacement 5.3 gaskets like mhale etc. i need a cable driven throttle body that will fit the tbss intake. i was looking at the holley sniper tb on summit its like $180 do you guys have info on them? other than that what else am i missing to get this swap completed? i only have access to 93 pump gas but when i go to the track is when ill buy some e85. also think ill get the denmah kit for intercooler the piping wg and bov. i need info or links to whatevr else you guys think i should get from dipsticks to bolts etc lol. should i just grab new TSP head bolts for $60-80 on their site? what flexplate do i need to look for? the engine has the flywheel still on it. i want to get this swapped and running for as little as possible because ill build a 5.3 block overtime while i drive this set up. but i woukdnt mind this set up lasting for a little while lol im sure the gen 4 rods will survive the power levels im looking for. how about a decent boost controller that isnt top notch for 7 second cars. if im leaving anything out lmk and i will adress it its hard to remember every single piece to an engine off the top of my head lol
