Need Help! Asap!!! Pleeaassee!!!
Need Help! Asap!!! Pleeaassee!!! Hey everyone. I am in the middle of the blower install and I have a few qeustions. First is that I dont have any instructions for using the SD-concpets system does anybody have any? Also I am hooking up the inline pump and i have a easy qeustion. The relay is setup like so
what is 87a used for???? cause there is 87 and a87a! ahhh i am so agraivated also. the guy who sent my injectors which i need tomorrow if they dont get here i am screwed! GEERRR this sucks. Thanks guys.
Nick
what is 87a used for???? cause there is 87 and a87a! ahhh i am so agraivated also. the guy who sent my injectors which i need tomorrow if they dont get here i am screwed! GEERRR this sucks. Thanks guys.
Nick
hi there, i asume you are talking about a standard 5 prong relay. well, 87a has a connection when the relay has no power. 30 is the connection that connects to 87 or 87a. when activated or not, 85 and 86 need a power, and the other a ground to work, so for example, to run your pump, you have both 30 and 85 to a switched positive source. then you have 86 strait to a ground, then 87 goes to the pump positive, and the other pump wire gets grounded, and then you leave 87a empty.
I got it wired up and i was testing it. I have power going to the relay. I have a good ground, i have good connections at the terminals on the pump. When I turn the key to the on position, of coarse the pump primes, and the part on the terminal where you splice into the grey wire for the intank becomes light but VERY VERY dark. So not much power. I think this is correct that the inline only really comes on under WOT? is that correct? Thanks for the help again
