A guess on HP
Thread Starter
TECH Enthusiast
iTrader: (17)
Joined: May 2005
Posts: 607
Likes: 0
From: Brentwood CA
A guess on HP Im currently rebuilding my motor with forged internals
Lunati billet rods (6.125)
diamond forged blower pistons -8cc dish
AFR 205 heads (66cc)
TR224 114
10-12#'s with D1SC
T56
Moser 12 bolt
Stock 346 cubic inches
was wondering if you guys can give me an estimated RWHP Im hoping for 550-600.
Also can you guys figure out the commpression ratio with this setup and diffrent gasket thicknesses I tried it on the calculator but I know that the pistons stick out of the block and it doesnt do that on the calculator so I know that it's not right ( hopfully in the 9.7 range for smog purposses).
Lunati billet rods (6.125)
diamond forged blower pistons -8cc dish
AFR 205 heads (66cc)
TR224 114
10-12#'s with D1SC
T56
Moser 12 bolt
Stock 346 cubic inches
was wondering if you guys can give me an estimated RWHP Im hoping for 550-600.
Also can you guys figure out the commpression ratio with this setup and diffrent gasket thicknesses I tried it on the calculator but I know that the pistons stick out of the block and it doesnt do that on the calculator so I know that it's not right ( hopfully in the 9.7 range for smog purposses).
