Ever had a Mondo Bypass sticking Open??
Ever had a Mondo Bypass sticking Open?? I'm getting much lower boost at the motor than I expected. I'm still tuning with the wideband so I'm creeping slowly up on the RPM, but even at 5600 I have never seen 4lbs.
Wondered if the Mondo could be sticking, and took it apart tonight to check. Ended up greasing the shaft which felt like it could bind open or shut or partway between.
Seen any thing like it or other suggestions?
383, 9.4:1, V-2 SQ, 7" crank pulley, 3.06" blower pulley, 3" piping to/from large Bell FMIC (core is 23"Wx6"Hx4.5"D, with hot air flowing through the 6" lengths).
Thanks,
Jim
Here's my setup:
Other photos:
http://home.mindspring.com/~jim_fisk/id1.html
Wondered if the Mondo could be sticking, and took it apart tonight to check. Ended up greasing the shaft which felt like it could bind open or shut or partway between.
Seen any thing like it or other suggestions?
383, 9.4:1, V-2 SQ, 7" crank pulley, 3.06" blower pulley, 3" piping to/from large Bell FMIC (core is 23"Wx6"Hx4.5"D, with hot air flowing through the 6" lengths).
Thanks,
Jim
Here's my setup:
Other photos:
http://home.mindspring.com/~jim_fisk/id1.html
