Will SVO30#'s on TurboTech T-60 work.
Will SVO30#'s on TurboTech T-60 work. Since i have pulled my stroker motor for a while and put a stock on back in im going to put my turbo kit on the car. It has a T60 with it and is the base kit with adjustable deltagate. I only plan on runnin 5 lbs of boost. Already have a 255 walbro intank pump. Will this with Svo 30 pounders work with my stock setup? and also what about a adjustable regulator do i need one? or will the stock regulator work? It will have a Ed wright tune also. I just want a Safe and very reliable setup. Also if i put the Maf infront of the turbo inlet can i blow the compressor blowoff athmosperhic? or will it cause a A/F spike? Thanks Justin Hagerman
Launching!
Joined: Jan 2002
Posts: 299
Likes: 41
From: Detroit, Murder City
Re: Will SVO30#'s on TurboTech T-60 work. The standard Turbo Tech stage I kit now includes a set of Bosch 30#/hr injectors and a Walbro GSS340 in-tank pump. This setup is good for about 5-6psi on the stock PCM. With the proper custom programming, you should be able to safely support about 7-8psi on the 30# injectors.
Re: Will SVO30#'s on TurboTech T-60 work. you should be able to use low boost (around 5psi) with the 30lb'ers
And if you have metered air escape via BOV, your car will stall.
to bad you got rid of your 9.4:1 stroker engine that would rock with your turbokit.
And if you have metered air escape via BOV, your car will stall.
to bad you got rid of your 9.4:1 stroker engine that would rock with your turbokit.
Re: Will SVO30#'s on TurboTech T-60 work. No i havent got rid of my stroker setup im useing the motor to fab up my new Thumper setup. Its going to be a Innovative T-80 R-trim setup with a Indy gate, and thier multistage boost contoller. Its going to have a 316 Series Stainless 2-1/2" I.D. log, with 1-1/2" primarys and a 4" downpipe. I just gotta get my new tranny and rear before i put it in my car. With the stroker motor N/A it made good power, with 15 lbs it should make execllent power.
Re: Will SVO30#'s on TurboTech T-60 work. sounds like you'll have a mean setup. But if your using the stroker motor with the turbo its going to be pushing alot of air. i wouldnt skimp on injectors, use at least 50lb'ers
Re: Will SVO30#'s on TurboTech T-60 work. I plan on useing FAST system and some 80+#'s injectors on my big motor. Im just useing these on my stock motor with a Stage 1 TurboTech setup. Also on the BOV can i put it infront of the MAF and blow it off atmosphereic, or will it still stall the car out or give it a rich spike.
