Turbonetics Suggestions...
Thread Starter
TECH Enthusiast
iTrader: (2)
Joined: Apr 2005
Posts: 572
Likes: 2
From: Gold Country California
Turbonetics Suggestions... Going to get new Turbonetics compressor housings and wheels for my TT stock bore forged motor. Have new Turbonetics .68 T4 turbines, Ptrim shaft and bearing housings. Purpose of new T4's was to upgrade but they wont fit what I have so Ill just get the rest. Fully ported heads and a nice set of headers. Street car. What should I look for as far as the housings and trim? Part numbers would help. Probably no more than 15PSI.
I run a pair of 60-1 hi-fi turbonetics with .68 or .69 A/R if I remember. One come in a Tang and one is on center, I have on center. They have very tiny compressor housings and will make close to 1300 hp at the crank maxed out. That is PLENTY for there small size! They only have 3" inlers and 2" outlets! I get full boost by about 3200-3400 rpm and they should help me to about 800 rwhp on pumpgas! I am running a fat tune with no timing right now at 15 psi and am at about 700+ rwhp right now.
Last edited by nitrorocket; Jan 1, 2006 at 07:13 PM.
