new LPE 2 step
new LPE 2 step I have my 2 step installed but no matter what side of the transbrake button I connet the power wire to the 2 step is always activated.Does any one have any ideas or has any one used this yet?
I installed mine on a toggle switch. I only used 2 wire's. 1 is the ground and I think the other is the green. If I used all 3 wire's it stayed on all the time also.I will double check.
Here are the install instruction from Lingenfelter. http://www.lingenfelter.com/document...tionsv1.21.pdf
You should be able to wire up the transbrake like the instructions have the auto with a line lock on page 7. The 2 step only needs 12v applied to the yellow wire to be activated.
You should be able to wire up the transbrake like the instructions have the auto with a line lock on page 7. The 2 step only needs 12v applied to the yellow wire to be activated.
I used one recently and wired the yellow wire to a toggle switch, then through an LED light into a momentary pushbotton switch, which triggers the 2step and linelok at the same time, push the momentary switch one more time and it releases both at the same time. LPE's instructions have a diagram to wire it up this way, and it works great!
Hope this helps,
Ed
Hope this helps,
Ed
