Yet another PCV thread
Yet another PCV thread I recently added the LS6 valley cover to my car and this is how I'm thinking of running my new crankcase breather setup.
Does anyone see a problem with it?
Does anyone see a problem with it?
Some may argue that while in boost you're not getting proper crank ventilation but I have had no problems.
I just wanted to make it easy to get to that breather to clean it. I'm thinking I should run two separate breathers off each vent instead.
I'm not sure how big of a deal it is to vent the crank case under boost either.
I'm not sure how big of a deal it is to vent the crank case under boost either.
You need to vent the crankcase under boost, or you'll push out the dipstick or a seal. A single breather should be enough as long as the line isn't restricted. You may get some oil on the breather element after a while.
I would keep a pcv valve in the pcv line, just to limit the amount of air pulling through there at idle,
or adjust the tb stop to let the throttle blade close a little more so the IAC can still manage the idle speed.
I would keep a pcv valve in the pcv line, just to limit the amount of air pulling through there at idle,
or adjust the tb stop to let the throttle blade close a little more so the IAC can still manage the idle speed.
You need to vent the crankcase under boost, or you'll push out the dipstick or a seal. A single breather should be enough as long as the line isn't restricted. You may get some oil on the breather element after a while.
I would keep a pcv valve in the pcv line, just to limit the amount of air pulling through there at idle,
or adjust the tb stop to let the throttle blade close a little more so the IAC can still manage the idle speed.
I would keep a pcv valve in the pcv line, just to limit the amount of air pulling through there at idle,
or adjust the tb stop to let the throttle blade close a little more so the IAC can still manage the idle speed.
Instead of doing the filter off the two rear valve cover taps, why don't you just leave the factory PCV line attached connecting the driver to passenger side and run a metco breather on the driver side where the oil cap goes? Looks cleaner and the breather is easy to get to because its right up front.
