diy twins....
diy twins.... well i started doing mine today and everything was going good till i tried to take a piece of hose off the walbro that i cut too short....then i broke the damn barb off the pump pulling on it. so my cheap easy set up just went up 100 bucks. anyone doing this be careful with the barbs they break alot easier than you would think. other than that its easy as hell to do the conversion. murphys law sux!
Joined: Dec 2004
Posts: 1,294
Likes: 0
From: Dallas (Richardson), TX, USA
Just FYI, I had to redo my setup a couple times for various reasons, and I just bought a foot of SAE 30R10 rated fuel hose and would cut the hose off and put new stuff on each time. This way I didn't have to tug on any fittings... I just sliced them off with a razor blade.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
