i am just not sure how to do the lines and fittings in the tank, I have a -8 90 bulkhead and than a - 8 to 3/8npt fitting. This just does not get me to much room to get anything else to fit. I can make this work but its alot of 90 deg bends and would need to have the fuel lines wrap outside the bucket. Anyone have any suggestions and how they would do this differnt? This is on a tbss and i believe the bucket is not quit so deep as a f body.

 

Anyone got any ideas of how i can do this differntly without using all the hard right angles?

I would have bought lonnies setup but i already had the pumps sitting around my shop from other project i never finished.

 

http://dagostinoracing.com/index.php...ducts_id=12346


Maybe this will help