Bulkhead Fitting w/Nylon Washers?
Thread Starter
TECH Fanatic
Joined: Nov 2001
Posts: 1,986
Likes: 1
From: Centrifugal City
Bulkhead Fitting w/Nylon Washers? Just doing a reality check on my dual pump setup.
We used a 6AN Bulkhead tapping into a plastic C5 tank just to the lower/right of the main sender plate. The bulkhead was straight, nut on back and we used 2 nylon washers. Red Circle in attached pic notes bulkhead location.
Everything seems to work well.
Anything wrong with this setup?
TIA!
We used a 6AN Bulkhead tapping into a plastic C5 tank just to the lower/right of the main sender plate. The bulkhead was straight, nut on back and we used 2 nylon washers. Red Circle in attached pic notes bulkhead location.
Everything seems to work well.
Anything wrong with this setup?
TIA!
Last edited by MelloYellow; Jan 15, 2005 at 03:41 PM.
