Aeromotive fuel rail question/problem..
#1
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Sep 2004
Location: Mustang, Ok
Posts: 1,332
Likes: 0
Received 0 Likes
on
0 Posts
Aeromotive fuel rail question/problem..
I was installing the Aeromotive fuel rails today and found that the rails are in a slight bind against the intake bolts, this holds the rails slightly off from optimal. The injectors are at a slight angle and not lined up as nice as I would like with the intake. It looks like the O ring on the injector is sealed with the intake fine but it bothers me enough to get a second oppinion.
Could I be doing something wrong?
Has anyone else with Aeromotive rails dealt with this issue? Are your rails right against the intake bolts?
Could I be doing something wrong?
Has anyone else with Aeromotive rails dealt with this issue? Are your rails right against the intake bolts?
#3
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Sep 2004
Location: Mustang, Ok
Posts: 1,332
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Nasty N8
I have heard that before I think there is a tolerance issue with them.
Nate
Nate
Thanks!
#4
Staging Lane
iTrader: (1)
Join Date: Jul 2005
Location: Norway
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Have those rails installed on my Ls1 Monte Carlo and I remember there was a slight clearing issue with the bolts. I just bent the rail fitting a bit out. Have drove it like this for a while now and have not had any problems.
Hope this helps.
Michael
Hope this helps.
Michael