Injector Offset Tunning
Thread Starter
Teching In
Joined: Aug 2004
Posts: 46
Likes: 0
From: West Palm Beach Florida
Injector Offset Tunning Hey guys,
Can anyone explain a good way to adjust the Injector Offset vs. Battery Voltage table to compensate for new, larger injectors. I have 50# RX injectors and have used AEM software to give me a compensation value for the new injectors. But I don't know if I'm suppost to add, subtract, or replace the old value with this new one... I've given a rough example of both the stock Offset table and the AEM table
STOCK AEM
volts usec volts usec
11 4500 11 650
12 4000 12 600
13 3500 13 550
Does usec mean MilSeconds? i.e. 4500 usec = 4.5 ms?
Is there a logical way to tune this using scanning software, wideband o2, ect? Thanks very much for any imput....
Mike
Can anyone explain a good way to adjust the Injector Offset vs. Battery Voltage table to compensate for new, larger injectors. I have 50# RX injectors and have used AEM software to give me a compensation value for the new injectors. But I don't know if I'm suppost to add, subtract, or replace the old value with this new one... I've given a rough example of both the stock Offset table and the AEM table
STOCK AEM
volts usec volts usec
11 4500 11 650
12 4000 12 600
13 3500 13 550
Does usec mean MilSeconds? i.e. 4500 usec = 4.5 ms?
Is there a logical way to tune this using scanning software, wideband o2, ect? Thanks very much for any imput....
Mike
