Driveshaft size
#1
Launching!
Thread Starter
iTrader: (13)
Join Date: May 2005
Location: Orange Tx
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Driveshaft size
How do I tell what drive shaft I need. I have a moser 12 bolt I bought second hand and I dunno what the pinion yoke size is and the stock driveshaft is to small. Can I just change the yoke on the drive shaft or is it easier to buy a new drive shaft? Any help will be greatly appreciated
#2
Teching In
iTrader: (2)
Join Date: Jun 2008
Location: McKinney, tx
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Most aftermarket rears will use a 1350 series U joint. I believe stock is considered a 1310 series. There are conversion U joints available but that option is clearly not the strongest. The driveline is only as strong as its weakest link and the 1310 side of a conversion U joint will only be as strong as stock.
Might as well go with an aftermarket driveshaft set up with 1350 series U joints.
Might as well go with an aftermarket driveshaft set up with 1350 series U joints.
#4
LS1Tech Sponsor
iTrader: (16)
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website