Bad luck! Bent axle!!!
#1
Launching!
Thread Starter
iTrader: (2)
Join Date: Sep 2008
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Bad luck! Bent axle!!!
Merry christmas to me.. While comming home from a concert I get cut off by some gangsters in a Camary with 26" wheels, I slammed into the median and cracked my rim. The wheel is cracked about 6" but just in the right area to where it's holding air. I drove the car another 5 minutes until I got home and everything seemed fine. The wheel doesn't even feel out of balance. I drove it to work today and home. Tonight though on the way home I can hear it started making a little more noise. Sounds like maybe the axle is bent and just rubbing the bearing a little more or it's tearing up the ring and pinion. This is a moser 9" with a Detroit locker. Any opinions welcome. And if anyone know the cheapeast place for a axle.
#3
On The Tree
iTrader: (6)
Join Date: Mar 2007
Location: Northwest Indiana (Highland)
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
had the same thing happen to me before. I replaced the axle and went on my merry way. One week later i was driving down to Florida and the rear started making noise. By the time I was in Clearwater I COMPLETELY destroyed the ring and pinion gears, over .060 was eaten off of the pinion. That ended up costing me over 1000$ on top of the 300$ to replace the axle. I'm pretty sure I have the most expensive 10 bolt ever.
Long story short, I got fucked cause the shop didn't check ring and pinion clearance.
My advise to you is to have it checked out asap, cuz its prolly outta spec.
Long story short, I got fucked cause the shop didn't check ring and pinion clearance.
My advise to you is to have it checked out asap, cuz its prolly outta spec.
Trending Topics
#8
LS1Tech Sponsor
iTrader: (16)
http://shop.brutespeed.com/Moser-9-A...er-9-Axles.htm
Here is a link to the Moser axles from my website. You should have 35 spline axles since you have a locker, but you'll want to make sure. Bob
Here is a link to the Moser axles from my website. You should have 35 spline axles since you have a locker, but you'll want to make sure. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website