Pulling the axle on a 12bolt

Reply Subscribe

Thread Tools

Search this Thread

Aug 23, 2012 | 11:59 PM

Canada204

Thread Starter

Staging Lane

iTrader: (3)

Joined: Apr 2010

Posts: 99

Likes: 0

From: Winnipeg MB

Pulling the axle on a 12bolt

I want to change my wheel studs on my moser 12bolt I have to pull the axles to do this how hard is it? Is it just the 4 bolts that hold it on?

Will I loose any fluids? Have to change any seals?

Sep 2, 2012 | 08:44 AM

Footlead

Launching!

iTrader: (18)

Joined: Dec 2008

Posts: 291

Likes: 1

You will have to take the back cover off and remove the c-clips that hold the axles in so yes u will lose fluid. Its not that hard to do. Google it.

Sep 2, 2012 | 08:47 AM

Footlead

Launching!

iTrader: (18)

Joined: Dec 2008

Posts: 291

Likes: 1

I think the Moser comes with good axle retainer plates but I think they still have the c-clips on the end of the axles

Sep 2, 2012 | 10:26 AM

ZL1Killa

TECH Resident

iTrader: (17)

Joined: Sep 2004

Posts: 3,747

Likes: 0

From: NC - Charlotte area

omg... you are just wanted to change studs out? WTF is everyone talking about... take your wheel off, pull the brakes, take the rotor off and then hammer the studs out, use spacers and lugs to pull new ones in. no pulling axle out... jeesh, the way I read that he JUST wants to CHANGE his WHEEL STUDS

Sep 2, 2012 | 04:27 PM

silverls1z28ofdeath

On The Tree

Joined: Apr 2010

Posts: 173

Likes: 0

From: Omaha,NE

That's all fine and dandy for stock studs zl1 killa but it don't work like that with long wheel studs man there isn't the room to do it like that

Sep 2, 2012 | 09:52 PM

Canada204

Thread Starter

Staging Lane

iTrader: (3)

Joined: Apr 2010

Posts: 99

Likes: 0

From: Winnipeg MB

Yeah no room for 3.5 studs by not pulling the axles plane and simple.

I have c clip eliminators so it was just the 4 bolts slid out easy and took about 20 mins per side

Reply Subscribe