driveshaft length
Thread Starter
TECH Enthusiast
Joined: Aug 2012
Posts: 536
Likes: 0
From: Vancouver, BC
driveshaft length say I get a direct bolt-in rear. In theory the driveshaft should be the same length right?
Last edited by trevmust; Nov 13, 2012 at 12:25 PM. Reason: made an oopsie lol
in theory.
My buddy has an old drive shaft of mine and it was too long, wouldn't fit. was too long by a hair. but fit prefect in mine. Both have the same setup.
I would measure it to make sure it fits. It's VERY easy to do and this way you get a prefect fitting driveshaft.
Brian
My buddy has an old drive shaft of mine and it was too long, wouldn't fit. was too long by a hair. but fit prefect in mine. Both have the same setup.
I would measure it to make sure it fits. It's VERY easy to do and this way you get a prefect fitting driveshaft.
Brian
It depends on the rear. If you get something other than a 10 bolt I would measure! I have an S60 so I had to go with a shorter one. The one sent out with the initial order was 40.25" and proved too long. After measuring 39.50" was what I needed.
