pulling like and ape on the shifter to get in gear!!!
#1
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Nov 2001
Location: sioux falls sd
Posts: 626
Likes: 0
Received 0 Likes
on
0 Posts
pulling like and ape on the shifter to get in gear!!!
ok i am having a problem with my t/a all of a sudden today, i have to pull like a gorilla to up shift and downshift the gears on my car, it just started. but when i have the car off it seems to go through the gears fine??? i mean when i am driving i really have to push them into gear HARD! sometimes bringing them forward and pulling back on em like i was powershifting or something. thanks for the help.
#2
TECH Enthusiast
iTrader: (4)
Join Date: Dec 2001
Location: Northern Indiana
Posts: 513
Likes: 0
Received 0 Likes
on
0 Posts
Re: pulling like and ape on the shifter to get in gear!!!
change the fluid. if that doesnt cure it then your clutch is not releasing all the way. since you said it just suddenly started doing it i would lean towards it being burnt up fluid
[ January 17, 2002: Message edited by: chevyguy3 ]</p>
[ January 17, 2002: Message edited by: chevyguy3 ]</p>
#3
On The Tree
Join Date: Nov 2001
Location: Huntington Beach, CA
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Re: pulling like and ape on the shifter to get in gear!!!
I'm sure no expert on M6's, but does that at all sound like a bent shift fork?
I thought I read a thread somewhere with a problem like you describe and it was the fork that was bent.
Just an A4 drivers $.02...
I thought I read a thread somewhere with a problem like you describe and it was the fork that was bent.
Just an A4 drivers $.02...
#4
TECH Enthusiast
iTrader: (4)
Join Date: Dec 2001
Location: Northern Indiana
Posts: 513
Likes: 0
Received 0 Likes
on
0 Posts
Re: pulling like and ape on the shifter to get in gear!!!
bent shift fork would only affect one or two gears depending how its bent, and usually wont make it alot harder to pull/push into gear, but rather make it so that the gear isnt fully engaged when the shifter is places in the position for that gear
#5
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Nov 2001
Location: sioux falls sd
Posts: 626
Likes: 0
Received 0 Likes
on
0 Posts
Re: pulling like and ape on the shifter to get in gear!!!
went aheah and orderd a new slave cylinder, definately better than buying a new tranny down the road <img src="graemlins/formula.gif" border="0" alt="[Pontiac]" />