TA Girdle Cut Bolt Question
Thread Starter
TECH Apprentice
iTrader: (11)
Joined: Feb 2004
Posts: 382
Likes: 0
From: Tyler, Texas
TA Girdle Cut Bolt Question So onthe TA Girdle there are the reinforcement bolts on the left and right side of the TA logo. One of them was over torqued and stripped so I got a new one from TA. They sent me one that was too long but I needed to put it on, so I put it on and had to cut the head of the bolt off to get the nut on. SO basically I torqued it on, cut off the head, and then tightened the nut. Will this affect the strength of the girdle at all?
Thanks,
Lane
Thanks,
Lane
Thread Starter
TECH Apprentice
iTrader: (11)
Joined: Feb 2004
Posts: 382
Likes: 0
From: Tyler, Texas
Yeah I think theyre the preload bolts. Theyre the two biggest ones on either side of the ta logo. I got the bolt tightened down all the way, tightened the nut and then cut the head off becuase it was too long. So it sounds like it should be fine?
