Drag CAGS question...
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 301
Likes: 0
From: Woodlyn, PA
Drag CAGS question... I'm trying to figure this out in my head....
If the computer sends 12v to the CAGS solenoid I can figure it out.
However if the 'noid is always hot and the ECM completes a ground I have a question about that...
I have a lighted 3 terminal 20AMP switch (12V, ACCY, GND). How would I then wire up the switch?
If the computer sends 12v to the CAGS solenoid I can figure it out.
However if the 'noid is always hot and the ECM completes a ground I have a question about that...
I have a lighted 3 terminal 20AMP switch (12V, ACCY, GND). How would I then wire up the switch?
