moser axle seals
moser axle seals i just got my moser 35 spline axles in, but they didn't come with the housing seals. they just came with the bearings anyone know a part number for the moser housing seals that will fit the 35 spline axle?
Joined: Mar 2005
Posts: 1,599
Likes: 0
From: 32639 Groesbeck HWY. Fraser MI 48026
If Moser sent you the bearings with 1/2 inch rings packaged with them then the seals will be useless. Moser didn't figure out that the rings will contact the seals and just ruine them.
so i should be good to go without the axle housing seals? i already pressed the bearings and the rings on, the rings were 1/2 thick and the bearings have the black rubber ring around them.
Last edited by BIRDONNOS; Jun 13, 2006 at 10:40 PM.
Joined: Mar 2005
Posts: 1,599
Likes: 0
From: 32639 Groesbeck HWY. Fraser MI 48026
Yes, the last few I have build were without the inner seals and no leaks to reoprt. Put some RTV around the outside of the bearing and o-ring so it will not dry out.
I have 33-spine axles with the rings. Does this happen with the 33-spine and press on bearings also? I have a small leak on the drivers side and I was wondering what is the best way to solve this. The bearing with o-ring did seem to fit kind of loose when I put the axle in.
Sounds like you have addressed these issues before.
Sounds like you have addressed these issues before.
![6']['9's Avatar](https://ls1tech.com/forums/customavatars/avatar7527_3.gif){kind=avatar}
