How to Fix a REAR Lug? PIC REQUEST

Reply Subscribe

Thread Tools

Search this Thread

Jan 25, 2007 | 11:00 PM

IMJ

Thread Starter

TECH Enthusiast

iTrader: (1)

Joined: Feb 2005

Posts: 536

Likes: 0

From: ABUQUERQUE NM

How to Fix a REAR Lug? PIC REQUEST

so a while back i broke a wheel lug off of my rear end. i have traction control on the rear end. i did do a search. but my question is where is the speed sensor located on the backing plate? dose anyone have any pics of this? cause i was planning on taking out the sensor and knocking the broken lug through the hole where the sensor is located. also how do you take out the sensor dose it just screw in and out?

thx
isaac

Jan 26, 2007 | 12:06 AM

keliente

TECH Addict

iTrader: (22)

Joined: Jan 2005

Posts: 2,928

Likes: 1

From: Mooresville, NC

The sensor has a 10 mm bolt that holds it in. Unplug it, undo the screw and it pops out. As soon as you look back there it will be very obvious where it is

Jan 26, 2007 | 12:07 AM

MeentSS02

Kleeborp the Moderator™

iTrader: (11)

Joined: Mar 2004

Posts: 10,316

Likes: 6

From: Dayton, OH

As soon as you get under the car with the wheel off, you'll see it. On the driver's side (example only), if you are looking at it, it'll be on the lower right hand side of the backing plate. As soon as you get around the back side of it, you'll see the wire and connector that plug into it. It is held in place with a single bolt (15mm head I think).