Pinion angle ?
Thread Starter
Teching In
Joined: Mar 2007
Posts: 37
Likes: 0
From: Pa
Pinion angle ? Can anyone tell me what my pinion angle should be or how I figure out what it should be ? I have a 91 Z28 with a LS1 in it and T56. The car is lowered 2 inches all the way around except the spacers that go above the rear springs are missing, I plan on getting some and putting them in. I also have a Random Tech adjustable torque arm in the car so adjusting the angle should be easy. Any insight on this would be appreciated, Thank You. I am also new to the forum
Jay
Jay
Thread Starter
Teching In
Joined: Mar 2007
Posts: 37
Likes: 0
From: Pa
Thanks Bob, that is what the guy I got the car from said he thought it was but I just wanted to be sure. Any advice for setting pinion angle for when I take the car to the track and put some slicks on it ? This is all new territory for me. Thanks again.
Thread Starter
Teching In
Joined: Mar 2007
Posts: 37
Likes: 0
From: Pa
Thanks again Bob. Stuff like this worries me when it comes to replacing U joints, not that it is hard to do it is just a pain in the *** sometimes. I had a dodge ramcharger with a 4" lift and 33's on it and in the first few months I probably put more miles on wrenches replacing U joints then I did on the truck. That is a bit exaggerated but I replaced a lot of them. Thanks again.
