Diff Install
Diff Install My auburn diff has been going out, 1 wheel peal with sticky tires. My rear is whining worse and worse and I know some day soon something will fail and I'll have to invest in 9". But, for now I've been shopping for a cheap auburn to replace my worn one. What I wasn't thinking about, I have no idea how to set up the rear after installing the diff.
I have searched on here and read Auburn's installation. Is there a good write-up somewhere with required tools etc for a 10-bolt?
Thanks,
Brian
I have searched on here and read Auburn's installation. Is there a good write-up somewhere with required tools etc for a 10-bolt?
Thanks,
Brian
Hey, I sense sarcasm!! And, I meant a GOOD writeup (ok now that was sarcasm).
Seriously, I tried that link the other day and it just popped up a blank page. Thanks for pointing me in the right direction it works now!
Brian
Seriously, I tried that link the other day and it just popped up a blank page. Thanks for pointing me in the right direction it works now!
Brian
Originally Posted by 00PewterSS
Hey, I sense sarcasm!! And, I meant a GOOD writeup (ok now that was sarcasm).
Seriously, I tried that link the other day and it just popped up a blank page. Thanks for pointing me in the right direction it works now!
Brian
Seriously, I tried that link the other day and it just popped up a blank page. Thanks for pointing me in the right direction it works now!
Brian
Originally Posted by keliente
The website gnomes must have taken it down while you were trying to view it
Thanks again for the link, now I can enter into my endeavor fearlessly... Unless I completely break the 10-bolt before then.
Brian
